UDOO X86 Basic

Add to comparison | Report mistake

  Manufacturer: UDOO
  Official website: Visit (new tab)
  Category:  SBC / development boards

No description provided.
Rate this board
Sorry, no stores were provided.

  • You can try Amazon or eBay for "mainstream" single board computers, or Aliexpress, Banggood and GearBest for China-based SBCs.
  • For industrial single board computers, you can try requesting a quote either on the official website or (sometimes) on Alibaba
  • You can also suggest a (possibly international) store using the "Report mistake" feature.

Filter table:
Manufacturer UDOO
SoC Intel Atom x5-E8000
CPU Braswell (1.04GHz with 2.00GHz burst) (64-bit)
1.04GHz quad core
Co-processing units
GPU (graphics): 320MHz Intel Gen 8-LP GPU with 12 execution units
MCU (real-time): Present
FPGA (gates):
NPU (neural):
Size 2GB
Built-in / External:   Built-in
Type (e.g. DDR3): ?
Speed: ?
ECC (error correcting) RAM:
Internal storage
Built-in / optional:   Built-in
Type: ?
eMMC slots
SD card MicroSD card slot, up to 32GB
USB host 3 USB ports
Type: 3.0
SATA 1 port
Ethernet 1 port
Type: Gigabit
Wake-on-LAN    Supported
HDMI 1 port
Version: ?
Max. resolution: ?
Audio support:
Composite video (CVBS)
Display interfaces (LVDS, DSI...)
Camera interfaces (CSI, DVP...)
Audio output
Analog output: 1x (via 3.5mm jack)
Via HDMI:   Supported
Audio input
Line input:
Mic input: x1
Onboard mic:
IR receiver
Wireless connectivity
WiFi: Optional Wi-Fi 802.11ac
Bluetooth: BLE
Mobile broadband:
Other I/O
GPIO: x14
ADC: x6
PWM: x4
SPI: x1
I2C: x2
UART: x2
Arduino shield support    Compatible pin header
Raspberry Pi shield support    Not compatible.
96boards compliance    None
Real time clock (RTC)
Other interfaces
- Built-in Intel Curie module (32MHz Intel Quark SE MCU + 32-bit ARC MCU)
- 6-axis combo sensor with accelerometer and gyro
- Optional Transcend MTS600 32GB SATA III (6Gbps) SSD, available with performance kit
- 2x DisplayPort++ video interfaces
- Internal speaker header
- M.2 Key B slot with optional wireless module (802.11ac and BT 4.0), available with performance kit
- RC5 IR interface
- Up to 20x ext. GPIOs (LPC, 2x I2C, GPIOs, touchscreen management)
- Supports optional Udoo Bricks sensor modules via I2C connector
- Optional starter kit with 12V power adapter, HDMI cable, SATA and power cables, acrylic enclosure
- Optional performance kit with 32GB SATA, M.2 wireless, starter kit items
- Optional cluster kit with 4x power adapters

Curie I/O:
- SPI flash

- 3.3V input, protection against 5V overvoltage on all pins
- Optional 12V 3A AC adapter (USA/EU/UK) via starter kit or 4x adapters via cluster kit
Size 120mm x 85mm x 25mm
Weight ?
Power Input voltage: 3.3V
Power consumption: 1A - 3A
PMIC/PMU (power management) ?
Lithium battery support ?
Operating temperature ?
Price (might vary over time)
Android support    Supported
Windows support    Windows 7; Windows 8.1; Windows 10

Please note: HackerBoards.com assumes no responsibility or liability for errors or omissions in the contents of this page or any other part of this website. That said, we value your feedback and request that you email us regarding errors, omissions, or other suggestions to hackerboards [at] deviceguru [dot] com. Thanks!