LicheePi Nano

Add to comparison | Report mistake

  Manufacturer: Zepan
  Official website: Visit (new tab)
  Category:  SBC / development boards
  Date added: 2018/08/17

No description provided.
Rate this board
Quality:
Value
Performance
Reliability
Documentation
Community
   BangGood










Filter table:
Manufacturer Zepan
SoC AllWinner F1C100s
CPU ARM926EJS (32-bit)
900MHz single core
Co-processing units
GPU (graphics):
MCU (real-time):
FPGA (gates):
NPU (neural):
RAM
Size 32MB
Built-in / External:   Built-in
Type (e.g. DDR3): DDR
Speed: ?
ECC (error correcting) RAM:
Internal storage
Size 8MB
Built-in / optional:   Built-in
Type: optional SPI
eMMC slots
SD card MicroSD card slot, up to 16GB
USB host
USB OTG
SATA
Ethernet
Wake-on-LAN    Not supported
HDMI
VGA
Composite (CVBS) 1 port
Display interfaces (LVDS, DSI...)   RGB LCD 40-pin FPC (272x480, 480x800, 1024x600...)
Camera interfaces (CSI, DVP...)   CSI + 2x CVBS input (x1)
Audio output
Analog output: 1x (unknown port)
SPDIF:
I2S: x1
Audio input
Line input:
Mic input: x1
Onboard mic:
IR receiver
Wireless connectivity
Wi-Fi: optional via SDIO
Bluetooth:
Mobile broadband:
LoRa:
Other I/O
GPIO: x20
ADC: x1
PWM: x2
SPI: x2
I2C: x3
UART: x3
RS232:
Arduino shield support    Not compatible.
Raspberry Pi shield support    Not compatible.
96boards compliance    None
Real time clock (RTC)
Other interfaces
2x TV (CVBS) input, 1x output
Full HD Video Engine(H.264,H.263,JPEG/MJPEG,etc.)
Audio: Speaker x2, Mic x1
On-board resistive touch screen chip supporting resistive screen
Size 25mm x 20mm x 4mm
Weight ?
Power Input voltage: 3.3V - 5V
Power consumption: 54mA - 250mA
PMIC/PMU (power management) ?
Lithium battery support 3.7V input supported (no recharge IC)
Operating temperature -20°C to 70°C
Price (might vary over time)
$2
Android support    Not supported
Windows support    Not supported


Please note: HackerBoards.com assumes no responsibility or liability for errors or omissions in the contents of this page or any other part of this website. That said, we value your feedback and request that you email us regarding errors, omissions, or other suggestions to hackerboards [at] deviceguru [dot] com. Thanks!