Blueberry Pi

Add to comparison | Report mistake

  Manufacturer: "petit-miner" (DIY)
  Official website: Visit (new tab)
  Category:  SBC / development boards
  Date added: 2018/09/05

Product description:

"Another fruit single board computer (SBC), based on the Allwinner V3s system on a chip (SoC). The Allwinner V3s comes in an easy to solder 128pin TQFP package."

DIY SBC, more information here:

Rate this board
Sorry, no stores were provided.

  • You can try Amazon or eBay for "mainstream" single board computers, or Aliexpress, Banggood and GearBest for China-based SBCs.
  • For industrial single board computers, you can try requesting a quote either on the official website or (sometimes) on Alibaba
  • You can also suggest a (possibly international) store using the "Report mistake" feature.

Filter table:
Manufacturer "petit-miner" (DIY)
SoC AllWinner V3s
CPU ARM Cortex-A7 (32-bit)
1.2GHz single core
Co-processing units
GPU (graphics):
MCU (real-time):
FPGA (gates):
NPU (neural):
Size 64MB
Built-in / External:   Built-in
Type (e.g. DDR3): DDR2
Speed: 360MHz
ECC (error correcting) RAM:
Internal storage
Built-in / optional:   Built-in
Type: SPI flash
eMMC slots
SD card MicroSD card slot, up to 32GB
USB host
Ethernet 1 port
Type: 10/100
Wake-on-LAN    Not supported
Composite (CVBS)
Display interfaces (LVDS, DSI...)   RGB / TCON LCD header
Camera interfaces (CSI, DVP...)   MIPI/parallel CSI, headers for OV7670/OV2640 (x3)
Audio output
Analog output: 1x (via 3.5mm jack)
Audio input
Line input:
Mic input: x1
Onboard mic: (1 mic)
IR receiver
Wireless connectivity
Wi-Fi: 802.11b/g/n (RTL8723BS)
Bluetooth: 4.0
Mobile broadband:
Other I/O
GPIO: x26
ADC: x1
PWM: x2
SPI: x2
I2C: x1
UART: x3
Arduino shield support    Not compatible.
Raspberry Pi shield support    Compatible pin header
96boards compliance    None
Real time clock (RTC)
Other interfaces
3x SD / MMC controllers, 1/4-bit SD, SDIO, MMC mode
2x PWM channels, up to 24 MHz output frequency
Support RGB Interface with DE/SYNC mode, up to 1024x768 @ 60fps
Camera: Still capture resolution up to 5M with parallel interface; Video capture resolution up to 1080p @ 30fps with parallel interface

Audio codec: 2x audio DAC channels, differential microphone input, stereo headphone output, low-noise analog microphone bias output

USB 2.0 OTG controller with integrated PHY. Support High-speed, Full-speed and Low-speed in host-mode
Ethernet: 10/100, support full-duplex and half-duplex operation

3x UART controllers

SPI Full-duplex synchronous serial interface, Master / slave configurable. Mode 0-3 are supported

2x I²C controller, support Standard and Fast mode

MIPI CSI interface, pin compatible with the Raspberry Pi camera (no support in the linux kernel yet)
Header for an OV2640 and an OV7670 parallel camera
Wifi and Bluetooth (RTL8723BS)
Parallel RGB interface, compatible with 40pin parallel RGB displays
Five buttons for play, pause, next, previous and reset
Footprint for SPI Flash
SD card slot
Size 100mm x 65mm x 18mm
Weight ?
Power Input voltage: 2.7V - 5.5V
Power consumption: 300mA - 1A
PMIC/PMU (power management) EA3036
Lithium battery support Likely supported, no charge IC
Operating temperature ?
Price (might vary over time)
Android support    Not supported
Windows support    Not supported

Please note: assumes no responsibility or liability for errors or omissions in the contents of this page or any other part of this website. That said, we value your feedback and request that you email us regarding errors, omissions, or other suggestions to hackerboards [at] deviceguru [dot] com. Thanks!